Black Ghost

Made from premium vegetable tanned leather from the La Bretagna family in Italy. This leather has a smooth, waxy leather with a soft luster and natural depth. The finish carries a subtle sheen that enhances the tone while allowing the leather to develop character and patina with use.

The leather has a refined, smooth feel with a slightly firmer temper, giving the wallet a structured, durable build while still remaining comfortable for everyday use. The flesh side is clean and well finished, maintaining a polished look throughout.

Each wallet is hand made in small batches, with natural variation in wear patterns as the wax shifts and breaks in. No two pieces will age the same.

Part of the Reserve Collection. Limited run. No guarantee of restock.

Each Fire Keys wallet comes pre fitted with industrial adhesive for secure badge mounting. Follow the steps below to properly prepare and install your badge.

Preparation

1. Remove Badge Hardware
   Break off the rear pin and threaded post from your badge.
2. Smooth the Surface
   File or grind down the back of the badge until it is completely flat and smooth.
   A flush surface is critical for proper adhesion.
3. Clean the Badge
   Wipe the back of the badge to remove dust, oils, or debris.
   Ensure the surface is fully dry before installation.

Installation

1. Expose Adhesive
   Peel off the protective backing from the adhesive inside the wallet.
2. Align the Badge
   Carefully position the badge in the correct orientation before applying pressure.
3. Apply Pressure
   Firmly press the badge into place, applying even pressure across the entire surface for 20 to 30 seconds.

Cure Time

• Initial bond forms immediately
• Full strength is achieved after 24 hours
• Avoid handling or stressing the badge during this time

Alternative Method

If preferred, the pre applied adhesive can be removed and replaced with a two part epoxy for a permanent bond.

Important Notes

• Ensure the badge backing is completely flat before installation
• Once applied, the adhesive is not intended to be repositioned
• Improper surface preparation will reduce bond strength